Just look

Hampton-bay-ceiling-fan-light-doesnt-work, if your hampton bay ceiling fan has an oil bath, check the oil’s level and replenish it as needed. make confirmation every pin is fixed properly at its place.the screws of blades,housing switch and rod are fully tight. there is a possibility of over lapped wire connections in housing switch.or nuts of wires not fell.. Hello, my hampton bay ceiling fan light will not work either. it's a springview model and i have a switched outlet for both fan and light. from my light switch i have both black and red hot wires and they are both working with my tester., http://hamptonlightingadvice.com/ hampton bay ceiling fans troubleshooting questions answered. advice and information on hampton bay ceiling fans troubleshoo....

I have a hampton bay ceiling fan that the light doesn't work. the light is a 9" circline bulb. i have lost the manual on the fan. i have bought new bulbs and a new ballast for it., you'll need to remove the light kit from the fan, and take out the light switch inside. first, shut off the power running to the fan. you can do this from the circuit panel in your home. once the power is shut off, look at the base of the fan where the light kit is attached..

Most ceiling fans with lights will work when one just one bulb has burned out in a multi-bulb configuration. ceiling fans that use a single bulb won’t provide light if the bulb has gone bad. check to see that the bulbs are screwed into their sockets. check that the bulbs have the proper wattage for the ceiling fan light assembly., if the motor still doesn't work it could be the capasitor which is located in the nose (switch housing) of the fan. tech support for hamton bay fans is at 1-877-902-5588. they will need the model/upc located on the top of the motor housing..

Hampton bay ceiling fan remotes. if you are like me and have had a few problems with your hampton bay ceiling fan remote not working then this is the article for you. i don’t claim to be an expert but after researching many articles, i have put together a comprehensive list for troubleshooting your remote control., turn off the breaker supplying electricity to the ceiling fan at you main electrical panel if the tester does not light. remove the screws holding the switch cover plate over the ceiling fan and....

If you just installed the ceiling fan and the light does not work, the wires were not connected properly. consult the installation guide and correct the issue. when the light goes out post-installation and you have verified the function of the bulbs, the pull switch and the wiring, the only possible cause is the actual light socket.