Just look

Floor-lamp-wont-turn-on, step 1 repairing standing lamp that won't turn on standard standing or upright lamp that won't turn on. first thing is first: make sure that it isn't simply the halogen lamp that is blown. check the lamp for any black burn marks or a discontinuity in the lighting wire inside the lamp.. It is most likely not turning on because the contact is pushed too far into the socket. you can easily fix your lamp that won't turn on. i bought new led bulbs to replace the cfl ones and thought..., during those irritating moments where you reach over to turn the lamp on and nothing happens, the first thing most people guess is that the lamp is unplugged. if that’s not the case, it might be that the bulb has blown. so, what do you do? yup, go the cupboard for a replacement bulb and voila!.

Grab the two wires near where they turn down into the body of the lamp and pull up. the electrical cord will be pulled up through the lamp. you will want 6" of the cord extending above the lamp. place a small piece of electrical tape on the extra cord to hold it., if the breaker switch didn’t resolve the problem and the light is on a circuit that is active, then a bad outlet may be the issue. likely it’s an outlet that no longer has power running to it, using a test kit will quickly alert you if this is where the problem exists..

If you have a lamp with a loose socket that causes the lamp to flicker, to be difficult to turn on, or to just flat out refuse to light, you can replace the socket and give the lamp a new life. you can replace a socket so easily that, even if it’s not your favorite […], another thing to watch out for is the (usually) plastic part that unscrews can get stripped or thread itself so far down that it is hitting the lamp body, and thus will not allow you to turn it. i was able to temporarily solve this by adding a small brass nut to the threaded part and then put the plastic turn back on..

I have a floor lamp with two dimmer switches, one of which won't turn off the bulbs it is connected to. i'm not really a diy guy, but would like to resolve this problem so i can leave the lamp plugged in and turn it on/off with the switches., unplug the touch lamp and remove the light bulb if it still doesn't work. look inside the socket for a small brass tab. use your fingers, needle-nose pliers or a small flat-head screwdriver to lift....

An additional wire connects to the metal on the lamp. it is this wire that gives the lamp the ability to turn the light on and off when you touch any metal on the lamp. the control box can be...