Just look

Diy-hardie-siding-installation, step-by-step instructions: how to install hardie board lap siding, hardieplank lap siding, and siding products, trim and more. follow these instructions for a long-lasting installation. hardieplank or hardie board lap siding products carry a 30-year warranty and installation is not much different than installing regular wood lap siding.. Blind nail your hardie siding in place using 11 gauge roofing nails and a nail gun. make sure the nails go through the siding and into the studs along the wall. place the second hardie siding plank above the starter strip with a 1 1/2-inch overlap. the lap hides the nails from each previous course. shoot the nails into the planks 1 1/8-inches ..., fiber cement siding is pretty easy to work with, mainly just measuring, cutting and nailing it in place. when you start just make sure the first row is level and keep at it!! hopefully this video ....

Www.familyhandyman.com, james hardie’s seal of approval indicates products recommended for use by james hardie building products circular saw with dust collector circular saw blade with carbide-tipped teeth framing requirements: hardiplank lap siding can be installed over braced wood or steel studs spaced a maximum of 24” o.c. or directly to minimum 7/16” thick ....

Installing fiber cement siding (fcs)—such as hardieplank® —is easier than you might think, though there are some important differences from traditional wood siding. installation instructions may vary depending on the manufacturer, and check with your local building inspector for any code requirements. always follow these safety precautions ..., professional installers of cement fiber board such as hardieplank, certainteed, cerber, trap-loc, weatherside, gaf and cemplank can maintain consistent and l.... Rip and nail up a 3/8-in. thick treated wood starter strip along the bottom of the wall (above the foundation). this strip will tip the first piece of siding to the proper angle. measure and cut to length the first piece of siding and nail it in place (photo 7). leave a 1/8-in. gap where the end meets the corner board (photo 7, inset) and make ..., as a homeowner, you will work with a contractor, who will facilitate the installation of your james hardie® siding, trim, soffit, wrap and flashing products (including products with colorplus® technology). we have dozens of installation specialists throughout the u.s. and canada who are available to work with any contractor or builder.