Just look

Cement-board-siding-installation, installing fiberboard cement siding fiberboard cement siding looks identical to wood once it’s painted. when you want the classic look of wood siding coupled with lifetime durability, fiberboard cement siding may well be your best choice. fiberglass cement siding is a composite made of portland cement, silica and wood fiber.. If you’re hanging fiber cement siding, you’ll typically use fiber cement trim from the same manufacturer on areas like inward and outward corners. once cut to length (minus the recommended “wiggle room”), attach each trim piece by driving nails through it, the house wrap, and the sheathing and into wood framing., installing the siding like most siding, you will install the fiber cement boards from the bottom up when using a traditional, horizontal lap application. you will begin with a starter strip with weep holes that will allow moisture to readily escape..

Fiber cement siding should be kept covered while not been installed on a clean, flat and leveled surface. the siding must be protected from direct exposure to weather that could damage the cement siding before it is installed. if you need to move siding pieces, be sure to carry them by their narrow edge and support it when you cut larger pieces., in this video, this old house general contractor tom silva shares his secrets for working with fiber-cement siding. steps: 1. when cutting fiber-cement siding with circular saw, use a blade that has only four or six teeth. 2. to keep dust to a minimum, use a circular saw that’s equipped with either a dust-collection bag or electric fan that blows dust into a bucket..

Watch this to learn how to install hardieplank, james hardie's world-famous fiber cement lap siding., this instruction video show how to install hardieplank® cladding. hardieplank fibre cement cladding is a versatile, low maintenance weatherboard, which is co....

Fiber cement siding should be installed 6” or more above the grade level of the house with a 1”– 2” gap between horizontal surfaces like decks, steps, or adjacent roofs. flash above doors and windows, leaving a ¼” gap between the flashing and siding.